Pur RF-9999-1 RF9999 Replacement Filter, FM 9400B, RF-3375 compatible. 1-Pack
$33.99
- Description
- Reviews (0)
Description
Description
Pur RF-9999-1, RF9999 Replacement Filter, PUR MineralClear Faucet Filter fits all faucet mounts purifiers.
RF9999 Replacement Filter:Each filter provides up to 100 gallons of filtered water Certified to remove 99% of Lead, 96% of Mercury and 92% of certain Pesticides.
Experience clean, crisp tasting water with PUR’s MineralClear technology
The easy-to-change replacement filter fits any PUR Faucet Filtration System to provide up to three months of clean, delicious water. Created with MAXION filter technology, this filter reduces over 70 contaminants while its MineralClear design filters water over natural minerals for a fresh taste.Certified to remove 10 times more contaminants than the leading brand’s pitcher filter
- Removes 99% of lead and microbial cysts, and is certified to reduce many other contaminants
- Reduces trace levels of pharmaceuticals, pharmaceutical reduction is not certified by NSF/ANSI or state standard
- Filters water over natural minerals for a crisp, refreshing taste
- Replaces previous 3-stage filter.
- The RF-9999-3 fits all faucet mount purifiers.
Easy Replacement by RF9999 Replacement Filter
|
|
|
|
|---|---|---|
Unscrew cap and remove filter |
Insert new filter |
Replace cap and run water for 5 minutes |
I am writing this in response to several other reviews where buyers found the PUR unit indicator still flashed red when the replacement filter was installed. I had the same problem and did some research on the web, and found a tip that solved it. Inside the unit, with the filter removed (and the cover off) you will see a small plastic block on the side near the “bottom” (away from the open end).
On top of the block is another plastic strip that can be pried up with a fingernail. Apparently, this is supposed to pop up when you remove the old filter, and it gets pushed back down when you insert the replacement. This resets the indicator. I pulled it up manually, inserted the new filter, put it all back together, and lo and behold, the indicator flashed green. I hope this works for you, if you are reading this.
Reviews
There are no reviews yet.